Which interconnection technology is used in the manufacture of unconventional silicon solar cells?

The review was extended to include detailed description of the concepts and interconnection technologies employed in the manufacture of unconventional silicon solar cells. It was found that the predominant interconnection technology used in the manufacture of wafer-based silicon solar cells involves soldering of ribbon on the surface of cell.

Are contacts and interconnection technologies used to assemble crystalline silicon solar cells?

A review of contacts and interconnection technologies used to assemble crystalline silicon solar cells has been presented and discussed in this paper. The review was extended to include detailed description of the concepts and interconnection technologies employed in the manufacture of unconventional silicon solar cells.

How does interconnection of solar cells work?

244 Interconnection of solar cells results in bonded materials at the interconnection joint. In order 245 to ensure that the bond has adequate strength, the bond is tested to determine its peel force. 246 Peel force is the measure of adhesion strength required to part bonded materials.

Are solar cells interconnection technologies commercially available?

It can be observed from the table that conventional interconnection technologies for wafer-based silicon solar cells and for thin-film silicon solar cells are the only widespread and commercially available technologies. New concepts used in solar cells interconnection are either partially available or are yet to be commercially available. Table 2.

How are silicon solar cells interconnected?

As discussed previously, silicon solar cells are interconnected with one another either by the process of soldering or by the use of electrical conductive adhesive . The reliability challenges of each technique are widely reported by researchers.

Which interconnection technology is used in wafer-based silicon solar cells?

It was found that the predominant interconnection technology used in the manufacture of wafer-based silicon solar cells involves soldering of ribbon on the surface of cell. This basic technique is shown to be none ideal because the soldering process induces thermo-mechanical stresses in the cells and joints.