How to check the water level in a car battery?

Before checking the water levels in your car’s battery, make sure to wear safety goggles and disposable gloves to protect your eyes and skin from the electrolytes in the battery. Then, clean off the dirt from the top of the battery and open the ports so you can check the fluid level in each cell.

How do I check and re-fill my battery's water levels?

To check and re-fill your battery’s water levels, you do not have to remove the battery if the top of the battery is accessible. But if the top of your battery is not accessible and needs to be removed, follow these steps: Featured Section – Report continues below

What is battery water?

Battery water, on the other hand, is the clean water used to refill the electrolyte when its levels run low. The water used in battery water is usually distilled water or deionized water. It’s never tap water, as tap water may contain impurities. What Does Battery Water Do? Your flooded battery works with the help of the electrolyte solution.

How to properly water a car battery?

Here is the step-by-step guide on how to properly water your car battery: Start by wearing the appropriate safety gear. Disconnect the battery. Remove the vent cap and clean the surface around the battery terminals. This will prevent dirt from getting inside the battery. Open the battery cap and inspect the fluid level.

How often should you check the battery water level?

Thus, as part of your car battery maintenance schedule, you should check the battery water level periodically to ensure proper battery operation and engine performance. You can check the battery without special tools and, if necessary, bring the water to the correct level in a few minutes at home. Step 1

How does water affect a wet cell battery?

This water reacts to the environment in the same ways that water anywhere else does: it evaporates. To prolong the life of your wet cell battery it’s important to check the electrolyte levels and replenish them as they get low.